So you guys might have seen my post about replacing my stepper motors to fix my non working gauges. Good news is that they all work perfectly. Bad news is that somewhere in the process I might have mis-marked the stopping points aka the place the needles settle to when the LC is off.
Can one or two of you guys snap some pictures and post them of their gauges when in the resting position so I can adjust back to the factory? Specifically, I think my oil pressure and temp need a little adjustment. Much appreciated!!
Can one or two of you guys snap some pictures and post them of their gauges when in the resting position so I can adjust back to the factory? Specifically, I think my oil pressure and temp need a little adjustment. Much appreciated!!