Resistor value for hyperblinking LED signals (1 Viewer)

[Turbohardtop]

I was wondering what you guys used to get your LED signal lights in the metal bumper to blink correctly. Did you wire it in series or in parallel.

Thanks.

 

[GXO]

I swapped to a smart tap relay using a toyota 9 to 12 pin harness I repinned to make it work (and killed my DRLs) in my GX470.

6 ohm is the resistance for hyperflash usually. Make sure you put the resistors where they can cool and not touch any wiring as they tend to get hot.

 

[Tex68w]

I bought these but I have not yet installed them.

50W LED Load Resistor Kit - 2 Pack

6 Ohm, 50 Watt load resistor kit. Solves common LED turn signal problems with hyperflashing and bulb out warning indicators. Connect one across each LED turn signal bulb to simulate filament Tail/Turn signal bulbs. View Installation Diagram & Instructions [PDF]. Mount the resistor away from...

www.superbrightleds.com

 

[Turbohardtop]

I ordered similar ones as well and luckily they are also 6 OHM ones.

 

[TX GX460]

Wire in parallel.

 

[GXO]

I did the resistor thing and they get HOT. Like no joke hot. Plan accordingly.

 

[Tex68w]

Yea the heat is why I haven't messed with installing them yet, I am not sure it's worth it.