afgman786
SILVER Star
Flashing green with quick blue. Not same as green blue for calibration
Redarc RTH!!! (1 Viewer)
- Thread starter afgman786
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
CharlieS
GOLD Star
Last edited:
I had this last week.
not sure if this fixed it, but i disconnected and dried out the connections since everything was pretty damp when i hooked up. After driving 20 mins i looked down and it had remedied itself. Hooked up the next day and it was business as usual.
If it continues to act up and you need to reset the controller the easiest way I found to do it was to reset the whole car by disconnecting the negative wire from the battery. It is a bit of a pain because you need to restore a couple of setting in the car that are lost. What happened with mine (not sure of the cause) was that it was trying to calibrate and failing. That is what Redarc told me. They eventually had to send me a replacement.
Given that the RedArc pulls right from the battery, if you don't want to lose all the vehicle settings, you can always pull off the connector on the back of the RedArc, wait a few mins, and plug back in. Your module is likely behind the drivers kick panel. Should be easy day.
Give me a shout rthurston@redarcelectronics.com we can figure it out!
