Rear spring advice

[flipckyLC]

Any real world experience on best springs for a 100 series with a front steel bumper, sliders and drawer system (with some tools). I don't usually carry passengers in the back and this is a semi-daily so looking for something that's not going to compromise comfort too much. Would OME 2860 work or should I go for something with higher spring rate?

 

[JunkCrzr89]

front steel bumper, sliders and drawer system (with some tools)

That’s the setup I have with 860s and OEM Tokico shocks. But if I had to do it over, I’d probably either throw in some airbags with stock coils or get Dobinsons coils.

 

[sammybones]

I have basically the same setup but with RTT and skid plates. I went from 2860’s to 2863’s, when loaded up with gear they are better for me.

 

[flipckyLC]

That’s the setup I have with 860s and OEM Tokico shocks. But if I had to do it over, I’d probably either throw in some airbags with stock coils or get Dobinsons coils.

This one from Dobinson?

• C59-167 – 2″ lift with stock weight, 1.5″ lift with 150-220LBS constant rear weight

 

[JunkCrzr89]

This one from Dobinson?

• C59-167 – 2″ lift with stock weight, 1.5″ lift with 150-220LBS constant rear weight

Yes

 

[ga12r1]

863s