R151F to Vortec 4.8L V8 (1 Viewer)

[TomDK]

Hi guys

Trying to figure out how to do this.
I know about the Advance Adapters bellhousing kit which bolts up to this engine/transmission. But nut sure about what to do about flywheel and clutch.

Contacted AA asked if this kit would also install to Gen. 3 Vortec V8s. But other that the bellhousing would bolt up to the engine, they couldn't help me with flywheel and what clutch parts to use.

So, anyone here that could help me out?

Thanks,
Tom

 

[SNLC]

Have you tried calling Marlin Crawler?


Cheers

 

[TomDK]

Good idea

Have been over their website more than once. But never tried contacting them. Will try that.

 

[ferg]

The A/A bellhousing will support both the 153 and 168 tooth GM flywheels. The difference is the starter and where it bolts on. This is referenced to 350 SBC.

 

[TomDK]

I was just under the impression that the 350 flywheel didn't have the same flywheel bolt pattern as the newer gen3 vortec v8. But apparently it's the same.