Power steering leak and vacuum line (1 Viewer)

[bkfj40]

I ordered the crush washer gasket for a 94 FZJ 80 power steering leak. This is what I got

I was expecting two single copper washers. Is there anything else other than replacing the oring? It seems to be leaking around this washer under the bolt head

Unrelated, I have a vacuum hose that I can’t seem to see where it goes on the FSM. Drivers side beneath the intake - the smaller hose.

The larger hose goes to the blue control valve

On the plus side, this ol man has been almost brought up to snuff once we get the PS leak figured out. All new hoses, radiator, box, and ignition.

 

[bkfj40]

btt for the Sunday afternoon crowd. Hoping to figure out this PS leak

 

[Fj80oregon]

Your crush washer is correct.

 

[Fj80oregon]

Where is the smaller hose going? Can’t tell from your picture?

 

[OffRoadScott]

The bigger hose goes to that blue colored valve under the upper intake manifold and the smaller vacuum line attaches just to the left/towards the front of the vehicle under the upper intake manifold.

For the power steering that is the correct part, easier to install that then 2 separate washers.

 

[Fj80oregon]

What you doing with that power steering pump? And Toyota grill? hopefully sending to me!