2007 LC, installed a PX6 Android HU from Phoenix Automotive and followed guidance in this post to jump additional wires to the passenger airbag /seatbelt indicator harness - https://rrcs.zendesk.com/hc/en-us/articles/360041046611--98-07-LC100-and-LX-470-Installation
There are no error codes and the dash SRS light is not on, but when an adult passenger sits in the front seat the airbag is indicated OFF. If I apply weight to different parts of the seat I can get the airbag to go ON but it appears that once enough sensors are hit it goes to OFF.
It is a new LC for me only had it a couple of months and I don’t have confirmation that this was entirely working with the factory HU although I can reinstall to test.
Bad sensor? Calibration? New HU wiring or related?
Appreciate any guidance on where to direct my troubleshooting.
There are no error codes and the dash SRS light is not on, but when an adult passenger sits in the front seat the airbag is indicated OFF. If I apply weight to different parts of the seat I can get the airbag to go ON but it appears that once enough sensors are hit it goes to OFF.
It is a new LC for me only had it a couple of months and I don’t have confirmation that this was entirely working with the factory HU although I can reinstall to test.
Bad sensor? Calibration? New HU wiring or related?
Appreciate any guidance on where to direct my troubleshooting.