Parting out 93 fzj80- 1fz-fe engine - trans - xfer case - axles - body -

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

What is the condition of all the carpet?
I pulled the carpet out today for inspection. The rear carpet was kept under a WeatherTech rubber floor mat. It looks quite nice, as well as the rear fender well carpets. The front needs cleaned up a bit. Send me an email address and I'll forward you photos. Thanks, Paul
 
What about the LSPV for the rear brakes? Mine is rusted to the point of disintegration.
 
On the rear axle is a metal rod the connects to the top of the third member, an it connects to a valve that is mounted on the chassis that proportions the brakes. the chassis mounted part is what I am after.
 
On the rear axle is a metal rod the connects to the top of the third member, an it connects to a valve that is mounted on the chassis that proportions the brakes. the chassis mounted part is what I am after.
I'm working on the LSPV for you....one bolt is giving me a headache.
 
Hitch Wiring

I need the trailer hitch wiring.
From where it plugs into the loom above the spare tire carrier (behind rear axle) to the hitch.
 
Can you share more info on the roof rack? Pic's maybe?
 
I need the trailer hitch wiring.
From where it plugs into the loom above the spare tire carrier (behind rear axle) to the hitch.
Francis J. - send me an email address so I can send you photos of the harness. I want to be sure you get what you're looking for. Thanks. Paul
 
Photos of the truck after the accident.

Can you share more info on the roof rack? Pic's maybe?

PICS...Here are some pics. This is from the mourning after the drunk driver tried to decapitate me. Notice that the impact was sooo high that the wheel and tire were untouched.

The roof rack is a stock Landcruiser oem rack. SO if someone needed all or part of it, cross rails, etc, i can pull them off and send them to you.

Thanks,
Paul
2007_1210_031214.webp
2007_1210_031244.webp
2007_1210_031258.webp
 
Do you have the heater motor, in the dash.
I pulled out the heater motor assembly tonight. The plastic housing has some damage but the motor turns freely. I'll test it tomorrow night. Can I send you some pictures and you can make me an offer ? Thanks, paul.
 
Dang!...

I am gonna hold off for now but might check in later... Price is right but other $$ stuff has been coming up.. thanks for the pics. K.
 
Back
Top Bottom