Parting Out Parting 1997 Toyota Land Cruiser FJZ80

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Anything left?
 
High rise center console lid, Driver side recline lever cover, front mud flaps, Driver side front bumper extension, hood lifts, battery tie down. Thanks in advance!
 
PM sent
 
How much for the dash section of the wiring harness? I actually only need the two male ends of the plugs going into the relay box on the left fenderwell but realize this would render that section useless. Maybe a bit cheaper because you don't have to dismantle the dash and shipping could be in a small flat rate box?

Thanks

Jason
 
How much for the dash section of the wiring harness? I actually only need the two male ends of the plugs going into the relay box on the left fenderwell but realize this would render that section useless. Maybe a bit cheaper because you don't have to dismantle the dash and shipping could be in a small flat rate box?

Thanks

Jason
I only have complete harnesses. You need the harness which attaches to fuse box?
 
Correct. Not the engine part, the sectio n inside the cab. It will have about 8 plugs that come through the firewall and connect to the engine harness.
 
No its not the engine harness. Its the one behind the dash. It attaches to the ecu and dash fuse box. I comes through the firewall right at the steering wheel and connects to the engine harness right at the relay box on the drivers side fender well.

Here is a pic of mine coming through the firewall and the broken plugs

 
No its not the engine harness. Its the one behind the dash. It attaches to the ecu and dash fuse box. I comes through the firewall right at the steering wheel and connects to the engine harness right at the relay box on the drivers side fender well.

Here is a pic of mine coming through the firewall and the broken plugs

ECU harness that is. $100 shipped.
I also have most front end parts if needed.
 
PM sent
 
Parting out almost complete 1997 Land Cruiser 40th Anniversary model. Accident and rust free Northern California truck from new. Runs and drives fine.
Fair market prices.
I can ship/freight all parts small or big. You know the drill: to your pay pal's registered address.
Please list the parts you need and I will respond with prices and condition.
No locking diff's on this one

Silicon Valley.
Front bumper and end caps shipped to 85086 via fedX ground, which I find to be reasonable. If you know of a less expensive alternative, I am open to that. Can I get a couple of pics? Thanks. Rick Hartt
 
Back
Top Bottom