Ok, a little embarrassed here. I was feeling great as I was able to remove the nasty little rust pods that used to be nuts on both 02 sensors, but then i realized I have no idea how to undo these little electrical connectors. I managed to get the front one apart, but i'm not sure how, i just sort of poked at it and futzed around like an alien inspecting an abductee. But the rear one...no idea. I'm trying to avoid what i usually do, which is break it, then look at the broken pieces carefully and go "ohhhhhh, now I see".
Part of the issue I think is that it's clipped up on the little perch and it's difficult to see and reach. But again, it's unclear how to get it down from there without breaking the little pin that holds it on.
Any tips on how this connector works?
Part of the issue I think is that it's clipped up on the little perch and it's difficult to see and reach. But again, it's unclear how to get it down from there without breaking the little pin that holds it on.
Any tips on how this connector works?
Last edited: