Opinion on Lincoln Power MIG 200

[KLF]

My intended needs for a welder run from 20-22 ga sheetmetal bodywork up to occasional 3/8" for beefy add-ons to bumpers. I have a friend that is selling a Lincoln Power Mig 200. The specs in the on-line manual are vague. Anybody have experience with one of these?

Hoping fj40charles picks this up...

 

[fj40charles]

I don't know much about the powermig 200. You might need to try it out and see how it welds before you buy it.

Here is a review that does not make the pm 200 look very good.

Weld Talk Message Board and Online Forum - Hobart Welders

 

[KLF]

Hmm... not sure how I missed that one. Not exactly a glowing endorsement, even though that thread is almost 7 years old.

I think I'm just gonna stick to my original plan and get a Millermatic 211 AS. Stopped at the local Airgas place today, super helpful and nice there. Not really that much more money, for a much better machine IMO.

Thanks.