Hey guys. My wife's seats in her LX 450 are flubbed up, not going back all they way. I can hardly I've taken out, think I made worse. Anybody know of any interior place that I could take to?
LX 450
- Thread starter Mongofj60
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I'd start here.
https://forum.ih8mud.com/80-series-tech/386530-power-seat-wont-move.html
same thing happened to my wife's boss's 80. He found the missing cap on the floor board and put it back in.
https://forum.ih8mud.com/80-series-tech/386530-power-seat-wont-move.html
same thing happened to my wife's boss's 80. He found the missing cap on the floor board and put it back in.
Huh new guy apparently..
- Thread starter
- #4
No I used to be President of the club, been around since 2003. Not new asshat....
I love this thread.
Travis I'd check the caps. If they come out it will lock the seat. Had it happen on me. I've been lucky and found mine.
Travis I'd check the caps. If they come out it will lock the seat. Had it happen on me. I've been lucky and found mine.
I was making fun of johnlee but can take shots of you as well if you like
jfz80
Cruisin’
If you don't find the caps or even if you do. And they don't work you can push the rod behind the caps in with a pen or penny or anything but your finger! Sucker gets hot fast when it spins. This lines the gears up and you can adjust it to desired position and let go and it will likely only move forward. That's how mine is.
Gamviti has the new caps and gears if needed
And also if it is twisted on the two tracks you can get two BAS (big ass screwdrivers
) flatblades and go from front trying to turn the worm gear screws in unison once you have them even.
Good luck
Gamviti has the new caps and gears if needed
And also if it is twisted on the two tracks you can get two BAS (big ass screwdrivers
) flatblades and go from front trying to turn the worm gear screws in unison once you have them even. Good luck