Looking for Pictures of Sag PS Pump install on 2F using Smog Bracket or...

[Sputnik40]

Looked throught the FAQ - old links no longer work, trying to see if the Bill Dory style mount is located down low on the block: https://forum.ih8mud.com/40-55-series-tech/61613-power-steering-bracket-sources.html

Currently running the JT/MAF style bracket that mounts to the cylinder head (too high for my setup). Have a newer year 2F with holds for OEM PS bracket - but have removed the old smog pump mount years ago.

Need a solution that puts the Sag pump lower than what I'm currently stuck with...

Looking for pics using smog pump bracket mount - or other homemade bracket using 2F PS mount holes. Thanks.

 

[spotcruiser]

I mounted my sag pump off the air pump bracket.

Here you go. It was simple to make out of scrap 2x angle. It's stout and very adjustable.

 

[spotcruiser]

More photos. I'll try to dig up the dimensions that I documented for a friend.

 

[tucker74]

Realize this isn't exactly what you're looking for, but here's a toyota pump mounted on the 2F smog pump bracket with the old IPOR adapter:

Should be pretty similar for the Saginaw pump -

Tucker

 

[Sputnik40]

Both are good examples of exactly what I'm looking for - the cradle part made for the sag pump looks simple enough. Where was the tension adjustment mounted?

 

[spotcruiser]

Here's the rough dimensions. I just built it to fit the pump. The base of this allows a lot of adjustability front-to-back for belt alignment. There are two different lengths of air pump mount and I used the longer of the two, which I believe came from a 60-series truck. For tension adjustment, I used a Ford alternator adjuster, backwards, from a slightly longer-than-stock water pump bolt to a front bolt on the pump, which worked very well. I can probably find that part number if you need it. Pretty much any alternator adjuster could be made to work.

 

[35inchoverdrive]

Mark's Offroad has a pretty affordable one. I believe he has the tensioner assembly that he sells for it also.

 

[Spike Strip]

Middle of the page:

http://www.marksoffroad.net/1specials/1specials.html

 

[broth9640]

Not sure if you still have the smog bracket still, but I just did a little grinding on my current smog pump bracket. I also added this steel spacer from Ace Hardware. I have a tensioner that I grabbed from the pick and pull, but its a bit ghetto. I plan on fabbing another one later.

 

[broth9640]

A few more since those first ones were a bit blurry

 

[broth9640]

I also used a spacer for the tensioner of a bolt from the water pump. Again this will get reworked later for a better setup.