Hi all.. just put a set of old school 33x12.5 wheels & tires on my cruiser.. so I am selling the OEM 16" set of 5 wheels... $350.00 + shipping.. no curb rash.. all straight & true.. tires still on.. but will pull for shipping...
For Sale LJ78 OEM 16" Rims
- Thread starter Ebike toter
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #2
how wide are those? 7 or 8 inches? Thanks!
- Thread starter
- #4
If you mean the new 33's.. I think the 15" rims could be 10" wide.. but at p least 8.5".. I measured the stagger on the original 16"s with tire from the contact flame at about 5" & the 15" deep dish with the 33's was the same.. just had to remove the old school clio in balancing weights as they were clashing with some kit..
Got the tires off the 16" cruiser rims.. I'll post some pics tomorrow..
Cheers
Got the tires off the 16" cruiser rims.. I'll post some pics tomorrow..
Cheers
- Thread starter
- #5
Here's some pics of the 5 rims w/o tires..
Good looking wheels but I just bought some 2nd gen Tacoma 16'' wheels today!
- Thread starter
- #7
Some more pics
I'm looking for those center caps as well.
What's the backspace on these?
- Thread starter
- #10
Just squinted at my atrached pic.. looks like 3 3/4".. or so..
The wheels' width is 6" with 0 mm. offset so that equals 3.5" backspacing.
Thanks Thai,
I've always like these style rims, with a 3.5" backspacing these would fit on a 40 without spacers correct?
No problem. I highly doubt they would fit your 40 due to the width. The wheel's back side might rub your tie rod end, but the only way to find out for sure is to test fit them. Good luck!
- Thread starter
- #15
I'll check the weight for the 5...
- Thread starter
- #16
28lb 9 oz.
