Lift install help (1 Viewer)

[COS100]

Hi every one
Im installing a lift and need some help. I'm on the passengers side and can't remove the rear section on the torsion bar from the mounting bracket. Any suggestions on how to remove it? I have tried punches hammers and got out the BFH with no luck.

 

[JayM]

Hi every one
Im installing a lift and need some help. I'm on the passengers side and can't remove the rear section on the torsion bar from the mounting bracket. Any suggestions on how to remove it? I have tried punches hammers and got out the BFH with no luck.


View attachment 1382813

is there any pressure on the TB? If not I would use some heat.

 

[COS100]

No pressure on it
Any one in the springs have a torch??

 

[COS100]

Got a torch from a friend finally got the lift done. Just need to get the alignment. Then the start of next project of replacing the bumper. Looking at Slee or BIOR.

 

[timmbuck2]

I have a BIOR rear bumper ordered.

Be very glad you were able to get it off with a torch. I was late to CM last year because of the same issue. I had to cut the old torsion bar and drill a hole in the back of the bracket to punch it out, and this was after a lot of torching...

 

[COS100]

I have a BIOR rear bumper ordered.

Be very glad you were able to get it off with a torch. I was late to CM last year because of the same issue. I had to cut the old torsion bar and drill a hole in the back of the bracket to punch it out, and this was after a lot of torching...

What do you have on the front?

I had the saw standing by if that failed

 

[timmbuck2]

TJM on the front