leaf spring pins

[mookie]

does anyone know of a source (or happen to be sitting on a set that you would sell) for a pair of new fj60 factory rear leaf spring pins? (leaf spring centering bolts) i ordered some from man-a-fre and they were smaller in diameter than the factory ones that i removed. these fj60 springs are going in the front of my fj40 crawler so i need the beefy bigger ones...

thanks
Neal

 

[Rigger]

I got a bunch of that same sort of stuff for my '40 from Kurt at Cruiser Outfitters. Try him.

If this is for a '40, you should post in the '40 section.

 

[mookie]

i know this forum is for fj60's but these ARE fj60 leaf springs and fj40 guys wouldn't know anything about a source for these....

 

[cruiser88]

cruiseroutfitters

 

[lovetoski]

A cap head bolt works great. Fine pitch is easier. I forget what size I used last time. Measure your hole, and go to a good hardware store (home despot doesn't count).

 

[freds40]

Just bought some from NAPA this morning

Part # is CB-12 or 601-804R

 

[Rigger]

i know this forum is for fj60's but these ARE fj60 leaf springs and fj40 guys wouldn't know anything about a source for these....

Right you are. Sorry about that. I retract the statement to post in the '40 section.

Cruiser Outfitters is a good source for the parts. So is Cruiser Dan.

 

[Dave-T]

Greaseable ones are nice

 

[lowenbrau]

I get the 7/16" ones at my local parts place. They're $4 a pair and are a tiny bit larger than the factory ones. You have to wiggle them a bit to get them through. Greasing them doesn't help much.

 

[weak-link]

spring pin, not bolt

Greaseable ones are nice