Knucle Wiper Ring Question...

[cruiser88]

That's what I thought but wanted to make sure. I guess if they won't work for me, I could always offer them to someone on here who could use them.

Thanks

Yep they fit.....just put them on my 84 mini....no longer bolts needed...just a little squeeze to get them started.

Once again, they are displaying their lack of knowledge about their products.

Yep...happened on 3 things I have ordered in the last two weeks.

 

[Spike Strip]

Wish I had seen those before I spent $60 on new ones from TLC ....

 

[Tinker]

Ordered mine from Gary today. Curious that they "don't do part numbers" in their order-taking, just descriptions. Not that I'm an old order-entry expert. Wait a minute, I am!

Anyone have the size, thread pitch, & length of the original bolts?

 

[JLH911]

Jose... if you buy them and they do not fit... I'll buy them off of yah.....

No you won't buy them off me....I'll give them to you!

 

[smkymntn]

So is the final concensus that these will fit on 86-87 60's?

 

[tonyota]

Great product...used them on both my minis & my 83' FJ60......Can't see em' changin the knuckle for 86' but can't prove they didn't either....all my stuff is 85' & older.

 

[Overlord]

So is the final concensus that these will fit on 86-87 60's?

Yes, I have them on my '87. Good to go!

 

[smkymntn]

Great thanks

 

[djawahir]

Ok guys,
I think the original size of the knuckle wiper bolts were: M6-1.0 x 10mm (10mm hex head and 10mm long)

The ones that I installed were: M6-1.0 x 16mm (10mm hex head and 16mm long)(Grade 8.8)

I also used a split-washer and a flat washer on each of the new bolts.

I hope that helps!! Good luck

 

[JLH911]

Ok guys,
I think the original size of the knuckle wiper bolts were: M6-1.0 x 10mm (10mm hex head and 10mm long)

The ones that I installed were: M6-1.0 x 16mm (10mm hex head and 16mm long)(Grade 8.8)

I also used a split-washer and a flat washer on each of the new bolts.

I hope that helps!! Good luck

Thanks for that info as I'm going to need it myself.

 

[IndianDoc]

Great thanks

Adam there is a thread in the tech section I believe that covers the change and the fact that on a few later models the holes don't line up perfect. Easy fix a drill and a few minutes was all it took. Sorry don't remember the exact thread or I would have put it in for you. Still looking Good!!

 

[smkymntn]

Thanks Doc-I will hunt it down