KDSS front swaybar measurements

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Dude I would do it, but it is 120 during the day here and there is not any way in hell I am getting under my truck in that heat!
 
I'll try and get at it later today when I'm at my shop...right now I'm hanging with my two little guys.
 
Could I bother someone take some front swaybar measurements? Inner and outer frame mounts, end link mount to end link mount? Thanks....

Are you thinking of adapting it to an 80 series? Could be a hot set-up!
 
120!

Thanks guys.... the whole reason my 80 isn't done is my little ones... and I wouldn't have it any other way.

This will be for the Tundra. According to the TIS webpage the frames on the the Tundra and 200 series are the same width. Looking at the two suspension diagrams leads me to believe the front will be an easy swap... but a couple measurements never hurts. The rear will be quite custom but there so much room back there it dosn't worry me.
 

Users who are viewing this thread

Back
Top Bottom