JD2 bender (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

jstncse

Crawling over something
Joined
Dec 15, 2010
Threads
70
Messages
1,368
Location
Albuquerque
Anybody have a JD Squared tubing bender they would like to sell or rent? I need to get a cage built before it is too late.


2" and 1.5" dies would be very helpful also
 
Your cage is going to be out of square tubing?
 
I have a full cage and kind of wanted to go to a stock roll bar. Check out my build thread, there are some pics on the first page. It even has a seat cradel. If you are interested in it maybe we can work out a deal.
 
I have a Metaltech cage to install but it only has the A and B pillars so I was going to bend a C pillar and some custom cross bars to complete the cage. That along with frame tie ins I am looking at about 15 custom bends.
Originally I was going to use the factory roll bar as the C pillar but I have decided against that as I get closer to building. If your cage is 2" tubing I may be able to use the B pillar from it as a C pillar and some of the cross bars. My factory bar is in fair shape with 1 hole drilled in each of the rear uprights. All of the factory padding is there and in good shape. Let me know if you would like to look at it.
 
Well.........I guess this problem has been solved.
 
Do tell.....


Lets just say I should spend more time paying attention at family functions than just looking for the hot girls.:D
 
LOL!!!!!
 
Lets just say I should spend more time paying attention at family functions than just looking for the hot girls.:D

Am I the only one who threw up a little in my mouth reading this?
 

Users who are viewing this thread

Back
Top Bottom