Ironman Deluxe Bar installed on a BJ70

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Finished

Finished up the wiring and put everything back together .
The bottom right switch is for the PIAA lights (Its a re-purposed defogger switch from a 60 series) as I had a crappy looking rocker without a indicator light .
The switch next to the heater controls is the one that came with the Ironman bar wiring harness . It didn't want to fit as its just a little too small so I took an old rear wiper switch from a 60 and gutted it out. I then cut the guts out and smoothed out the inside and the new switch popped right into the modded one that then snapped into the dash .
Came out looking pretty good , and maybe I'll brake down and clean out the garage enough to get it out and drive it :doh:

Sorry about the 2nd pix as it was a little hard to get the shot with the flashers in the on at the right time
P6240219.webp
P6240217.webp
 
I bet that lights up the dark nights.
Is there no aircon in CDM BJ70s?
 
outside shots

Heres some pixs with it outside its junk cocoon . 1st time out in a couple of years :doh:
P7030222.webp
P7030223.webp
P7030224.webp
 
Great Car!

It looks wonderful !
I have exactly the same car, but after I saw these pictures, I think I will go for the ARB Bar.
 
car looks realy great !

one of the best looking winchbar on the 70 imo !:clap:

only disadvantage of all bullbars on the heavy duty 70,s imo is the iron hiding the indicator lights wich i love so much on the 70:D

But it does protect it on the otherhand so.. always something*******:censor:
 

Users who are viewing this thread

Back
Top Bottom