Recently completed this mod along with the rear Russian camera spray nozzle, since I had to take the back panel off for both. (Might as well only remove that gummy plastic once.). Turned out well, and very easy to do. I tapped into the switch wiring side and used a 7.2V battery molex connector I had salvaged from some old batteries and RC cars. It didn’t have to be water proof as I put it on the cabin side of the plastic sheet. Also, I used plastic flex shielding as I ran it through an existing hole in the inner skin.
The switch I purchased off eBay, was a flush button momentary switch. In the location it’s installed and being flush, should prevent accidental triggering by our dog or anything I carry in the back.
The switch I purchased off eBay, was a flush button momentary switch. In the location it’s installed and being flush, should prevent accidental triggering by our dog or anything I carry in the back.
Last edited: