Howdy all,
I'm in the final stages of a rebuild of my 73' F engine. I'm to the point of putting the rocker arm assembly back on. Two of the push rods are elevated.
What is the best approach for getting the rocker arm assembly on there and sitting flush? Should I back off the adjustment screw on the two arms with elevated rods? If I do so, when I retighten them, will it have enough force to press the valve spring, or am I likely to cause damage?
Any assistance is appreciated!
Brent
I'm in the final stages of a rebuild of my 73' F engine. I'm to the point of putting the rocker arm assembly back on. Two of the push rods are elevated.
What is the best approach for getting the rocker arm assembly on there and sitting flush? Should I back off the adjustment screw on the two arms with elevated rods? If I do so, when I retighten them, will it have enough force to press the valve spring, or am I likely to cause damage?
Any assistance is appreciated!
Brent
