Heritage D-Pillar emblems clarified (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Eric Sarjeant

Ed Martin Toyota (Indianapolis)
Supporting Vendor
Joined
Sep 22, 2018
Threads
86
Messages
1,085
Location
Noblesville, IN
Website
www.edmartintoyota.com
I get inquiries fairly often about this, so decided to make a quick video for clarification about the Heritage D-pillar emblems vs the retro FJ40 emblems. Hope this helps.

 
Get compliments all the time on mine and @Eric Sarjeant made the transaction super simple. Plug and play.

4E7BFB2B-2238-4041-A934-8ED79E131450.webp
 
@Eric does it include mounting instructions to ensure correct placement of the badges?

Thanks,

Nik
No, you can eye it pretty easy. Use alcohol for prep and cheat with masking tape lines before pulling tape backing off.
 
$300 for a pair? Ouch.

That would be per badge.
Clearly made to discourage from buying them unless you actually have a Heritage Edition.
You can get every OEM sticker/badge/designation set for LX570 for less than $300

7E389E89-FF6E-4123-8FFB-81130B2F4688.webp
 
Since the old emblem does not have the slight bend, how do you attach the whole emblem?
 
Since the old emblem does not have the slight bend, how do you attach the whole emblem?

Eric’s shop put the old emblems on my LC but they stuck out. I removed them and installed the Heritage emblems which were not available at the time of my build. Most have simply bent the old emblems.
 
Does anyone feel like putting these emblems on a non Heritage 2016+ seem overkill or enhance the vehicle image? There is a side chrome trim piece that already says Land Cruiser. However, it is blended in and not easy to see unless you looking for it. Hard to tell until I see some full side images of some non Heritage models with both emblems showing. Few that I saw from searches had only D pillar image showing. Since these are pricy, looking for some input.
 
Last edited:
I get inquiries fairly often about this, so decided to make a quick video for clarification about the Heritage D-pillar emblems vs the retro FJ40 emblems. Hope this helps.


This guy is legit. Just watched a bunch of his stuff. I'm going to buy these from him and pay more just to thank him.
 
You can cut the studs on the FJ40 emblems with a dremel, then sand it down smooth. At least that's what I did
 

Users who are viewing this thread

Back
Top Bottom