Head sensor tightening torque values (1 Viewer)

[Malleus]

The FSM is mysteriously silent on this point:

I know I need to orient the TVV so that the hoses are pointed where they were when I pulled it off, but the others don't seem to want to tell me how tight they need to be.

What is the consensus?

 

[nukegoat]

TVV is 22 ft lbs. ECT sensor is like 17.5 etc etc. Knock sensor I think 33. Go to the Service Specification pages (ss-10, ss-12) for more.

 

[Malleus]

TVV is 22 ft lbs. ECT sensor is like 17.5 etc etc. Knock sensor I think 33. Go to the Service Specification pages (ss-10, ss-12) for more.

Thanks very much. After you told me where to look, it was obvious. Why couldn't it be on the installation page like everything else?

 

[nukegoat]

Thanks very much. After you told me where to look, it was obvious. Why couldn't it be on the installation page like everything else?

I dunno, there's a few more like that in there. Too bad Toyota didn't open source the FSM so people can suggest updates and corrections