Front hub whisking/rattling noise

[DJWUZJ]

ReGreased my hubs and spindle this weekend, along with new pads. When I got done, it had a more pronounced whisking/rattling sound that worked itself out, only when turning. It went away until I noticed it today.

If I'm turning hard and moving at 15-20+ mph, it sounds like a whisk in a steel pan. I inspected everything and all looks good, but havens popped the wheel off yet.

Dust cover?
CV getting ready to go?
Bad bearing?
Any other thoughts?

Thanks in advance!

 

[TTO5]

Check the dust shield on the back side of the rotor. It should look a thin piece of metal about the same diameter as the rotor

 

[super50]

FWIW I was told by a mechanic that I will hear a grating noise when making slow turns when my bearings need replacement

 

[DJWUZJ]

Need to get my ears checked... Ended up being passenger rear dust shield

 

[TTO5]

Yeah I had mine do that also on the pass rear after a brake job. Would only do it on ramps getting on highways. Glad it is solved.