Flush mount Lights in bumper

[Mrtwooooo]

I've been looking at the Flush mount Dually lights Rigid makes and I've been wondering how it would work with the flush mount version in the 80 series front bumper.

Have anyone looked into this or done it? I've done some searching and nothing comes up with the flush mount lights.
I'm thinking some of the D2 Dually flush mount lights in the Driving pattern would look nice and clean in the bumper.

What's everyone else think of that?

 

[titanpat57]

I think they would work fine....everyone that has them, loves them.

I just wish they made it in a round version...I'd replace my fogs in a heartbeat.

 

[alviswilson]

loler inspections

Its good, but the lights are too big and use the battery alot. so if you really wanna thes lights , i think you have to us cutout with these lights. so that no intruption occur.

 

[Mrtwooooo]

They are no wider than 6 inches and no taller than 4 inches and they each use 34.5 watts. So what do you mean they are too big and use too much battery?

 

[Corbet]

You did not indicate but I'm assuming the OEM bumper? I've considered the same but there is not a location on my ARB bumper that would allow them to be installed pointed straight ahead & flush mounted. Light output is good. Only disadvantage I see is you will not have much control over aiming them short of shimming the mount. So you may be limited to high beam use only.