Wanted FJ60 Manual (31 Viewers)

[cruzerman350]

thanks for the replies. i think i may have found one a little closer to home. i will keep you updated it that falls through.

 

[red77f250]

78 fj40 transfer case

need a rebuilt ot good/used transfer case for a 78 fj40 w/ 4 speed tranny
email: blrdart@aol.com
cell: (253) 405-9079

 

[pbgbottle]

where you at i have a set 3 inch with confer shackles

 

[65swb45]

Which one would be the 'lower'? I have two exhaust manifolds from a 3FE. I thought they were front and rear half. I did not take the engine apart, so I am not sure. IIRC, one has the EGR port and the other does not.

 

[65swb45]

I found one!

Call me.

 

[jeffery_1965]

WTB Running Board support/mount

Hello,

Looking for a running board support for my '77 FJ40. I don't think it makes a difference, but I need the drivers side support.

Please let me know cost and shipping.

Thanks,

Jeff

 

[sonoranfun]

Why laugh, not point in laughing at you when we should laugh at anybody that takes you up on it! I don't blame you, I wish I could help, I have a 1982 JC7 I'm trying to sell now for the same reason. Thank god I could stretch my money enough until one sold! Good luck!

 

[IDave]

Heatriser Stop

Anyone have a spare heatriser stop? It is the little metal bracket that has an H and a C and bolts to the intake to limit the travel of the heatriser flapper valve counterweight. F engine type 1958-1974.

I had a good one that I got from Mike AKA TreeRoot. But the bolt must have worked itself out and it disappeared (cragnabbit!).

 

[JRFJ4-]

Trans/Xfr

I have a good transmission/transfer out of a 76 FJ40. I just pulled it out to swap in Chevy stuff.

I could let it go cheap, but I'm in Alabama. Shipping may be a problem.

Let me know.

J.R.
76 FJ40
Chevy 350
SM465/NP205
DANA 60/14 BOLT

 

[yournamehere]

Passenger side Oh S#!T handle.

I'd like to buy a tan/brown handle formy 60 with hardware if anyone has one. This is the one that goes over the glovebox.

Please and Thanks.

 

[1extrmfj]

Got one if you want I'll take a picture just to be sure it the right part and email it to you tomarrow. $25.00 shipped to you. My email is duffydietz@yahoo.com

 

[Scott R]

Rear dropgate hardware

Chances are I will use other hardware, e.g. minitruck handles and such on my rear dropgate, however I would like to go OEM if possible. Anyone have the hinges, latches and chains for sale?

 

[yournamehere]

Hand throttle kit for fj60.

Anyone have an extra hand throttle kit lying around? I'd like to have one for winching.

Please and Thanks.

 

[yournamehere]

Cigarette Lighter for fj60

I am also in need of a cigarette lighter socket. I need it for my phone charger. Mine appearently doesn't work.

 

[trw]

Trailer rental

I'm looking to rent a trailer to go up to MN and pick up a 70' plymouth. U-haul wants too much for my budget and no one else local will do it. If anyone down this way within a couple hours has one they wouldn't mind renting out that would be great.

thanks
tom

 

[plainolejeff]

I need to one with the EGR port. Thanks.

jeff

 

[Landpimp]

if your pedal has the bracket and the little mount for the cable, then all you need is the cable and knob, I recall about $40 from the dealer.

Anyone have an extra hand throttle kit lying around? I'd like to have one for winching.

Please and Thanks.

 

[Tlburrow]

Club stickers

I would like to collect stickers from all the clubs. If you are a club member and would like to sell or donate a sticker, I would appreciate it. I own a pretty decent 1975 FJ40. I live in New Mexico. email me at tlburrow@aol.com
Thanks

 

[Radd Cruisers]

Still looking, not so much cheap anymore but rust free or very little with original paint.

Thanks
Rob

 

[NorCalDoug]

Hey, I want some too.
Send some to me