Wanted FJ60 Manual (26 Viewers)

[tlc4me]

Re: FJ40 Seat Cover

Rick,

Just got finished doing the seats in my 82 fj 40, I went with the complete SOR kit, it fits great but not the same material as the original toyota material. If you are lucky to find someone with the seat only, make sure it is for the driver or passenger side as they are different. The material is the same and the fit is the same but they will have a hole in the side of the cover for the hardware, tilt control.

Bill

 

[Jacknasty]

Strange request.......

I am trying to find the ashtray that goes in my driver's side/rear area armrest. It was missing when I purchased my 1996 Cruiser. My interior is grey, if it matters. If anybody knows where I can get a hold of a used one (read - cheap), I would appreciate it



Thanks

 

[Corbet]

Re: Heater valve needed 1976 FJ40

Travis, can you post a pick?

 

[DRTDuck]

Used ARB Bar for 80 Series

Well, the subject tells it. An ARB bar is my next anticipated upgrade, if anyone has or runs across a used one, that would be great.

 

[Gumby]

Re: Used ARB Bar for 80 Series

I see them very occasionally on ebay. They often end up going for more than you can buy one from the better sources. 4wheel parts (with free shipping) and Sams Offroad are pretty much the best I've seen at right around $650
I looked for a long time before I finally buckled under and bought mine from midwestlandcruiser.com

 

[FJ40man]

4" lift springs

I need some front springs only for a 71 FJ40. Hopefully iclose to the PNW. 8)

 

[cruzer]

Re: Looking to buy Aux Fuel Tank, JF40

Straylight

PMed you with my email

No i am not parting out....i am aquiring though...aux tank doesn't work for what i want to do.


Stew

 

[LT]

Re: Looking for roof rack in WA state

The PO had the roof rack custom built by some fab shop in Eugene, Oregon.  It's 1" or 1 1/2" tubing and there is no rust on it.  The clamps are really easy just a bolt and there are rubber pads for the rain gutters.  

Travis

 

[BUCKSHOT70]

LATCH FOR 68' FJ40

NEED THE LATCH FOR THE TOP PART OF THE BACK DOOR???

 

[76FJ55]

Re: Need T-case for 78 FJ40

If you're still searching for a t-case I have a spare out of a 79 fj55. I pulled the engine and trany for my 55 but didn't need the t-case. When I bought the truck I was told it had around 79K on it but no way to verify it. The engine and trany I put in mine are good. I can only assume the t-case would be also. I drove the truck on and off a trailer but thats all I know about it. if you're interested let me know.

 

[76FJ55]

Re: Disk brake axle

I have a complete 79 FJ front disK axle in southeast Missouri. I'm in St Louis but the parts truck is in Cape Girardeau. I'll be down there this weekend if that helps. email or call if you're interested.
Simon
scdr4d@umr.edu
319-922-9596

 

[miker]

Need nylon Speedo gear for FJ40

Need a 15 or 16 tooth nylon speedo gear for a 79 fj40 transfercase. Would like the 15 but will settle for the 16 too. If you have two of them, I'll take both.

Located in California, zip 95993. Willing to pay shipping.

Thanks

Mike
cruiser_man@lycos.com

 

[fj40crusher]

Re: Looking for roof rack in WA state

How Much?

 

[mcfj40]

Windshield Frame for 73 fj40

I am looking for a windshield frame in good(rust free/dent free) condition. If anyone has one they need to get rid of, please let me know. I am located in Memphis, TN.

Thanks

 

[zetasig]

Re: LATCH FOR 68' FJ40

I have a back hatch off a 68 Im not using, what exact parts are you looking for?

Like the handle?

If you have a photo email it to me I will check and get back with you.

rojewsw@nationwide.com

 

[cruiserbrett]

Re:  Heater valve needed 1976 FJ40

Yeah i do have it then, i bought it from a friend of mine thinking my heater was fawked but really i think it's the core.  Anyways it's in good condition, came off of a FJ55, has some surface rust, and i payed $20 for it.  So $20 and $3-$5 in shipping and it's yours.  It doesn't come with anything else just he heater valve itself.

Travis

FJ55 heater valves are differnet than FJ40's. Function is same, mounting different

 

[cruiserbrett]

Re: FJ55 stuff wanted...

Here is the new style a/C

 

[cruiserbrett]

Re: FJ55 stuff wanted...

And the old...

 

[LT]

Re: Looking for roof rack in WA state

$200 o.b.o.

 

[FJ_MONSTER]

4spd shafts

i need 4 spd shafts and 4spd pinion flanges for a swap im into.
2f/4spd/3spd in a 73'.
any help guys?