Great meeting everyone. Had a blast. Didnt break or mash anything so it was a good day. Need to get that rear locker installed soon.
february 11th meeting at gulches!!
- Thread starter the gimpey one
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #62
I had a great time riding with jimbo and johnlee. Jimbo is flat out crazy!! I was simply amazed at how well the 4runner did. I can't wait to get the dent back up and running!!
Loved meeting those who I did not know. Those I did know I was elated to see again. Had a good time for the 4 hours or so I was on the trails. Got home safe and no broken parts. Priceless!
Posted up some of the pic's I got on the low country sub site, wish I knew how to insert a director line so I would not have to load all those again. Anyway the pic's are over in the low country clubhouse section. Doc
Hear are a couple that I did'n post on the other site
Posted up some of the pic's I got on the low country sub site, wish I knew how to insert a director line so I would not have to load all those again. Anyway the pic's are over in the low country clubhouse section. Doc
Hear are a couple that I did'n post on the other site
Lenny - glad to hear Chloe still likes wheeling with you. If you didn't leak too much grease, then you can replace the OEM steel band with a standard pipe clamp. People say they throw off the balance of the wheel, but I have run them and had no balance issues.
Here's a whole thread on what sizes to buy and where to get the fancy ones that have smooth edges. I think the 100 series CV's are similar enough that these sizes listed will work for you. https://forum.ih8mud.com/pfran-leds/521348-100-series-cv-boot-clamps-bands-mcmaster-carr.html
Last edited:
Thanks for the tip! Steve mentioned this to me as well and I am researching away now. I'll probably replace em all while I am in there.
-Lenny
