Do all 84-90 70 Series...

[Mr Cimarron]

I used that on my Ute.

Same here. Haven’t installed them yet but they plopped down over all the existing grooves and seem like a perfect match. Mine is a 98.

 

[MiniPigg]

would it be possible to get a couple photos of the tank under the seats? How does it attach to the frame and how high is the floor ? Is it high on both sides under the seats?

 

[coldtaco]

Did you happen to mention what model 70 you have?

 

[MiniPigg]

I’ve a 1985 BJ70 w/ 3B and H55.

 

[coldtaco]

If you look in my build “AK HJ-75” about 3 pages from the end there is a picture of my Ute from the rear, there you can see where the forward (main) tank is and also see how the floor is raised. I highly doubt that you could fit a factory tank under the floor even if you cut that part of the floor out and welded in a floor from a Ute/troopie. I have had a -70 before and there really isn’t much room underneath.

 

[MiniPigg]

If you look in my build “AK HJ-75” about 3 pages from the end there is a picture of my Ute from the rear, there you can see where the forward (main) tank is and also see how the floor is raised. I highly doubt that you could fit a factory tank under the floor even if you cut that part of the floor out and welded in a floor from a Ute/troopie. I have had a -70 before and there really isn’t much room underneath.

Those pics say allot. Thanks for letting me know about them. The floor is much higher and if I ever did decide to use the replacement floors I would end up trimming to much metal off of them to justify the cost.