I have a set of those mirrors at the museum. I can measure them tomorrow.
Couldn’t find this mirror PN on partsouq.com...
- Thread starter SKULLYOTA
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
this would be great , thank you
Measurements are center-to-center.
(A) top row, 72mm
(A) bottom row, 67mm
(B) front column, 42mm
(B) rear column, 47mm
(A) top row, 72mm
(A) bottom row, 67mm
(B) front column, 42mm
(B) rear column, 47mm
Thank you very much .
Anybody Mount These on the Doors ? The both wholes 72mm are the same as the wholes for the Standard mirrors
The mirror base contour will not fit flush on the door. There is a lip on the bottom edge. The lip can not be ground off because of the pivot location for the lower arm.
ok, this is a pity, they look much more better as the australien monster towing mirrors. Perhaps able with a distance plate ?
I imagine you could fabricate a spacer. The hole mounting pattern is an irregular quadrilateral and that may pose some challenges.
sark
42601-60262-03
Time to find your closest friend with a 3D printer and bring them a blueprint and some brau.
