carburetor rod missing . . . where to buy?

[Red Panda Roll]

Congratulations. I didn't know that SOR wanted that much. Back when I had my 40 people were sometimes giving away their Aisan carb or selling it cheap when they got a Weber and I was taking advantage of their generosity. I included the little clips on the ends, so be careful unwrapping it so you don't lose them.

Thank you!

I did notice the "micro pins" were there. Thanks for being so careful.

 

[Red Panda Roll]

I got it installed (right side up on the second attempt) today. It fits perfectly. Now I just need to figure out why the truck won't run without the starter engaged. Thanks again!!

 

[Pin_Head]

I got it installed (right side up on the second attempt) today. It fits perfectly. Now I just need to figure out why the truck won't run without the starter engaged. Thanks again!!

That issue is likely due to a bad ballast resistor (the metal covered ceramic resistor on top of the coil / ignitor assembly). Check for continuity across the resistor posts and if it is open, then run a jumper wire temporarily until you can get a new resistor.