Bumper on Sammy (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 4, 2006
Threads
52
Messages
2,011
Location
Sourdough?
Finally back on MUD, well from mobile app I'm here again at least. Well here is the build of my bumper for the Sammy. It took a couple hours to get the over kill tow bar that was half inch material welded for almost ten inches on both sides and too the original tow points off using my plasma torch. Not only time consuming and messy but hard on my frame!
ForumRunner_20110831_223734.jpg
ForumRunner_20110831_223805.jpg
 
:lol: I think he fell asleep mid 2nd post.
 
The mobile app crashed and wouldn't reload.... so I'm on my computer now.....
1314314937212.jpg
1314387722136.jpg
1314399693161.jpg
 
So here's more....
1314405326099.jpg
1314405337007.jpg
1314411817057.jpg
 
Gettin' close :D

SO... I didn't take into account that the fairlead needed to be bolted on which required a nut on the inside of the bumper. I made it just large enough for the winch to fit.... well I did a little adjusting with the grinder and vualla...

Decided to put the winch controller inside, it's kinda pimp :D
1314474937624.jpg
1314479562132.jpg
1314499181675.jpg
 
Finished :D

Hey thank you again for your helping me out with knowledge Aric!!!!!! How do ya think it turned out?
1314499230226.jpg
 
Looks very clean. Hope to get the front of mine looking like that someday.
 
Where's the beef?:hmm: :meh: :rolleyes:

:cool:
 
Quarter inch plate on the front of Sammy ... just barely beefy enough lmao!

Uh for now I mounted the stock signals behind the grill. I just turned them ninety and zip tied them in.... if I can't find anything I like better I'll get new lenses (mine are all busted up) and fab a bracket back there...
 
Oh and to Navy :flipoff2: I HATE WHITE PEOPLE!!!
 

Users who are viewing this thread

Back
Top Bottom