Wondering what would be the correct brake line length on the rear or a fj40 with a 4'' lift and 2.5'' shackles and where is the best place to get them. Thanks
Brake lines
- Thread starter rsacruiser
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Recommendations:
Utilizing all safety measures!; forklift one tire up until the opposite side tire is just touching the ground. Measure the distance from the stock frame hanger to axle mount (brake line tee) on the "drooping" side.
Add length to accommodate changes in direction in the line and a slight "over extension" likely while wheeling.
Then either buy a manufactured flex line (stainless steel braided recommended) or have one made up by your local industrial hose shop.
Best of luck
Someone may chime in who has a 4" lift but each Cruiser is different by virtue of mods and onboard equipment. SO a direct measurement will ensure the best fit for your rig.
Utilizing all safety measures!; forklift one tire up until the opposite side tire is just touching the ground. Measure the distance from the stock frame hanger to axle mount (brake line tee) on the "drooping" side.
Add length to accommodate changes in direction in the line and a slight "over extension" likely while wheeling.
Then either buy a manufactured flex line (stainless steel braided recommended) or have one made up by your local industrial hose shop.
Best of luck
Someone may chime in who has a 4" lift but each Cruiser is different by virtue of mods and onboard equipment. SO a direct measurement will ensure the best fit for your rig.
Last edited:
- Thread starter
- #3
Thanks
I have a total of 4" lift(+ or -) and used a flex line from a Caravan. It came with the 10mm "T" fitting and it was about $12 IIRC. However I repalced all my hard lines and may have changed the "drop point"....dunno.
Ed
Ed
