Sounds simple, but make sure they’re installed and torqued correctly. Also if you don’t have wheels that have the recessed areas on the back of the wheel you’ll need to trim the studs. If you have oem wheels you may not need to. I’ve run .75” bora spacers up front with tundra wheels and did not need to trim. Not sure if rear would need trimming, I did a 1” in the rear.
Also does the spacer fit snugly to the hub before you tighten? And also off the truck, snugly into the wheel? I’ve had a couple sets of boras I had to send back over the last 2 ish years due to improper tolerances. Annoying and takes a couple months due to their turnaround time, but they did make it right.