Ok, I’m new so if this has been discussed forgive me, I did my due diligence, as best I could, and didn’t find anything.
This is discussing the 1” rake needed for our trucks by design for handling etc.. from what I can tell this front to back difference is all drive/suspension related, change the front height with the torsion bars to achieve the correct height/angle.
Here is my question, would it be possible to “adjust” the length of your body mounts, front to back, to eliminate, or reduce this, body only apperance, from front to back. I know its not a major issue for most, actually for me either, it’s just something I thought about and was curious if possible.
So, staring with 1” up front then stepping down to 1/4” or 0” in the rear.
Not to start another body lift thread per say, just checking an idea.
This is discussing the 1” rake needed for our trucks by design for handling etc.. from what I can tell this front to back difference is all drive/suspension related, change the front height with the torsion bars to achieve the correct height/angle.
Here is my question, would it be possible to “adjust” the length of your body mounts, front to back, to eliminate, or reduce this, body only apperance, from front to back. I know its not a major issue for most, actually for me either, it’s just something I thought about and was curious if possible.
So, staring with 1” up front then stepping down to 1/4” or 0” in the rear.
Not to start another body lift thread per say, just checking an idea.
