So after taking all the bed liner off of my FJ while there is very little rust, Idiscovered that it has been rolled. The damage isn't that bad but I need to know what the dimensions for a '71 is so that I can pound it back into alignment. I need the wheel well height from the floor, hieght of the 2 half doors in the rear, as well as the hieght of the rear quater panels from the floor, particularly where they attach to the half doors.
Body dimensions for a '71 40
- Thread starter joeyg1973
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Here you go...I don't have the other view unfortunately.
- Thread starter
- #3
Is the 980 on the far right the measurement in MM from the ground to the top of the wheel well?
I believe so. I know that 745 is the bed to the ground. I think the dotted lines are the jump seats.
pb4ugo
SILVER Star
I would guess 980 is mm. And it apprears the measurement is from the ground to the top of the fender well. There are 25.4mm in an inch. So 38.58".
The back floor to the top of the fenderwell appears to be 235mm or 9 1/4" according to the schematic.
EDIT:
Disregard this. After further review, The 980 measurement apprears to be for the
back marker light.
Last edited:
- Thread starter
- #7
Unfortunately those only show you the measurements for all the attachment points to the body, not the body.
- Thread starter
- #8
Any chance someone can take the measurements on their truck and place it here?
Body dimensions for 71
I am assuming by 'floor' you are referring to the bed floor of the cruiser. I went and measured my tub. Here is what i got:
floor to top of half doors- 15in
floor to top of fenderwell-7 and 3/8in
quarterpanel height at half door mount-17 and 1/2in
Don't know if you wanted that standard or metric? Hope this helps. Steve
I am assuming by 'floor' you are referring to the bed floor of the cruiser. I went and measured my tub. Here is what i got:
floor to top of half doors- 15in
floor to top of fenderwell-7 and 3/8in
quarterpanel height at half door mount-17 and 1/2in
Don't know if you wanted that standard or metric? Hope this helps. Steve
- Thread starter
- #10
Standard works fine. I did mean from the floor of the tub. For the doors, can you give me the total height of the doors instead of from the floor?
total height of the doors is 15 and 5/16in.
