BJ60 Brake Lines

[fe sus]

I'm swapping out a master cyl, booster, etc and am having a bit of trouble figuring out how to run all the lines. The other BJ60 I have has a different booster and slave (the thing just below the master?) and the FSM I have shows nothing there at all. So. What goes where?

 

[roscoFJ73]

What you got there is a non load sensing proportioning valve. It sends a fixed amount of pressure between front and rear brakes,say %60 front %40 rear ,my guess.

The other type is the Load sensing proportioning valve which increase the pressure to the rear as a load is added to the rear axle.
Its fixed to the rear right frame rail and has a curved rod extending down to the axle.
As a load is added the valve is opened more allowing more brake fluid to the rear brake mechanism.

Each system will have its own unique set of brake lines.

 

[fe sus]

Hmm... I found the load sensing valve in my manual bit was in the rear like you say and didn't look like this. Okay... I can figure this one out... one line from the proportioning valve to the rear brakes, one to the front... and two lines from the master to the valve (one already installed). It's just brakes anyway, not anything important.