Aux reverse light wired into stock circuit? (1 Viewer)

[mep1811]

I'm looking at using a Vision X mounted to my tire carrier as a reverse light. I'd like to wire it in with the stock reverse lights. Should I be able to just tap into the existing reverse light ? The AMP draw in very low. I prefer the light coming on when I go into reverse rather than using a switch. Thanks

9-32V DC
AMP Draw	1.25A (ea)
Watts	15W (ea

 

[gnob]

Should be fine if you swap your stock lamps to leds too, it definitely will be fine.

 

[mep1811]

Should be fine if you swap your stock lamps to leds too, it definitely will be fine.

That I did. Thanks