2fpower
SILVER Star
Anyone near Liberty Upull?
- Thread starter 2fpower
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Just drop the bed liner back in!
I have a good idea why. I'm almost afraid to ask, but what do you want a Frontier bed for?
It is for Josh's Ute project. Check out the link in his signature.
completely ignoring feasibility from a design standpoint, why not a Toyota Truck bed? Or something with a rolled edge?
Case in point...
Matt's Toyota Truck Bed Trailer
That'd look sweet, albeit a little out of place!
Case in point...
Matt's Toyota Truck Bed Trailer
That'd look sweet, albeit a little out of place!
2fpower
SILVER Star
- Thread starter
- #10
Diminsions. we spent two months hunting down diminsions of different beds and the older frontier was the only bed that would work.
The trick is that I want to be able to use a bed cover system that is made for a truck already, so I did not want to alter the width, yet I needed the inner structure of the bed to fit within the 80 existing size.
Plan is to basically take this bed, move the wheel well to center for our purposes, then "skin" it with the 80 rear door and quarter skin, to make it look like it was factory made.
I tried to convince Josh of doing a tray back as I know this is going to be a ton of work.
The trick is that I want to be able to use a bed cover system that is made for a truck already, so I did not want to alter the width, yet I needed the inner structure of the bed to fit within the 80 existing size.
Plan is to basically take this bed, move the wheel well to center for our purposes, then "skin" it with the 80 rear door and quarter skin, to make it look like it was factory made.
I tried to convince Josh of doing a tray back as I know this is going to be a ton of work.