Doing an SOA without going ahead with 80 axles is gay. Do it.
Anyone? - CLC Classifieds thread (18 Viewers)
- Thread starter Bodean
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
ok. But my 40 axles already have ARB.
Sell front. Reuse rear.
I love to weld up dat ass.
Take my already soa housings and put your gears,lockers,axel shafts, in um, Give me you sua housings... Problem solved. My project 40 axels are going to be soa into the red 40. I'll be needing some sua to replace them.
wait what....
Do it. Do it.
Any body need some of these? Saw these posted on bayou state fb page.
link it and be done chris. no steps. just go to the big show and put us all to shame ; )
Anyone have an 80-series LHD steering arm they're looking to sell? Needs to be the one that attaches under the passenger-side knuckle (tie-rod attaches on back, drag-link attaches to front).
Check with JRob. He has an 80 chassis that may have what you want......
Did you mean Rob? Rob has all the 80 parts.
No. Noel combined a good LC body and a good LX450 chassis/drivetrain to make a Lexota. Left over, he had an 80 rolling chassis with a knocking motor, but everything else was fine. JRob bought that 80 rolling chassis for the axles.
Awwww girl! 
jrob
Florence, MS
its hard to keep anything on the down low around this joint!!....LOL.
Bossman, I think you have something I will need in the future,...if your not gonna use it
Bossman, I think you have something I will need in the future,...if your not gonna use it