Any solution for better Cup Holders (1 Viewer)

[Alibaster]

Has anyone just poured silicone in it and made their own?

 

[JZinNM]

Good question. I walked out to snap a a few pics (front and back). As luck would have it, looks like the Tesla Model Y insert works in the back, too (with very little distortion; would certainly work for holding a drink):

View attachment 2704236View attachment 2704235View attachment 2704237

These look really good. Thanks!

 

[mudbutt]

Mine came in yesterday but got to put them to use today while making a run to Starbucks (that’s what this rig was built for).
mine is a 98 LX and the fit was spot on. Before my drinks would just move around but now sit tight.

 

[LC97MD]

Mine came in yesterday but got to put them to use today while making a run to Starbucks (that’s what this rig was built for).
mine is a 98 LX and the fit was spot on. Before my drinks would just move around but now sit tight.
View attachment 2709226
View attachment 2709227
View attachment 2709228
View attachment 2709231

Nice!

 

[Alibaster]

I wish they didn’t stick out so far. I have a set I didn’t put it in yet. I may cut the bottom to be flush and see how it works.