Hello everyone, Did anyone face the same problem that I am facing. After two weeks of deleting the rear ac lines the ac stopped blowing cold air and the ac button is blinking.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I have checked it with the gauge that comes with diy kit ( I know it is not the best). And it showed around 90psi and 100psiA/C blinking normally means it’s low on Freon.
No when I try turning it on the rpm rises for 4 seconds and then it starts to blinkWas the compressor on when you took the reading?
How did you do it and checked if it was the problem?My AC light randomly flashed during this past summer. Freon level was full, compressor operating properly. I ended up just moving the relays in the under hood fuse box. Problem solved. Apparently I need a new relay.
I will try to finding it thanksThere was a thread about this issue on the Mud. I just swapped the relay with one beside it. I am not near the vehicle now, so I cannot give you specifics. But since the swap, I have not had any issues at all. I believe the relay was overheating a bit.