A/C Cutout and Dash Water Temp Thread Size? (1 Viewer)

[Will Van]

Does anyone know the thread size and pitch for the A/C cutout switch on a 1FZ-FE motor?

Same question for the one-wire water temp gauge for the dash - What is the thread size/pitch?

 

[Will Van]

I just went ahead and ordered a couple of spare sensors. I’ll report back on the thread pitch and size for future enthusiasts.

 

[Will Van]

I think they are both M16 x 1.5 for the A/C Cutoff sensor and water temp gauge sensor.


I will post final affirmation once I test-fit.