78 FJ40 powertrain in So. Cal

[65swb45]

Location

United States

Pulled for a 1 ton chebby conversion. Prices are only good for a couple of days while I'm dismantling and putting the stuff on the shelves. After that, they become 'regular' inventory.

782F long block[ no accessories or harmonic balancer] with dented oil pan, was running good when pulled-$350
carb-$100
small cap electronic dizzy-$100
fine spline front 3rd-$300.
All the 'engine side' smog equipment is there too.

BEST to call me in the afternoons, 818-953-9230 and leave a message if I miss the phone.

 

[stuching]

Mark,
I'm interested in front 3rd. I'll call you tomorrow.

 

[65swb45]

Missed your call. Could you leave a message?

 

[numby]

Is the carb a Fed or Cali model?

 

[Cruiserdrew]

Pulled for a 1 ton chebby conversion. Prices are only good for a couple of days while I'm dismantling and putting the stuff on the shelves. After that, they become 'regular' inventory.

Mark-Are you doing these conversions now? I about fell over when I saw this.

Anyway, good price on a working motor and here is a bump for you.

 

[65swb45]

Is the carb a Fed or Cali model?

I am 99.9 percent certain it is a Cali model since it is sitting on top of an uber-rare Cali spec manifold THAT ISN'T CRACKED!!!!!!!!

numby, if you need a fed-spec model, I have a few of those as well.

Drew, no worries here. I did NOT pull the engine, or install the chebby, nor have I even seen the cruiser in question.