700r4/np203/splitcase (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 23, 2007
Threads
53
Messages
270
Location
new hampshire
Location
United States
for sale is a 0 mile rebuilt 700r4 with AA output shaft to mate to np 203 range box. an np203 range box, 4 bolt adapter plate to mate box to trans, the adapter plate to mate range box to split case and an fj62 split case. The LC case has been converter to manual shift using all toyota factory parts. The setup comes with a torque converter and lockup wiring kit, not installed. I also have a TV made ez setup for a vortec injected motor. This is basically a bolt in setup to run behind a vortec motor or any GM motor for that matter. all that is left to do is set up the tripple sticks. $1250 obo the setup is 38.5" long from bell housing end of case.
 
Last edited:
I will gladly palletize this and ship at buyers expense

photo (2).jpg
 
Location?

Sent from my iPhone using IH8MUD
 
Likely not your most desired route, but if you decide to part it...

I'm interested in the '203 to splitcase adapter; the '203 as well, but I'm afraid of the shipping:eek:

Please keep me in mind!
Thanks,
Jason
 
I'm hoping to sell it whole. This can be strapped to a pallet and shipped freight. It's not as bad as you might think.
 
I would only want the tranny and transfer case - I presume it would not be as simple as pulling the 203 out of the chain... I presume the tranny would then need to be modified to mate to the Split TC?

mark
 
It would be much better to go after a different setup. It's a lot mor involved than simply removing the 203
 
PM Sent
 
Lots of interest but no one has pulled the trigger yet. Price this stuff out. This is a good deal for someone.
 

Users who are viewing this thread

Back
Top Bottom