- Thread starter
- #61
You people are fast! Replied.
3D printed fix for floppy vents (1 Viewer)
- Thread starter mct75
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Outsane
Supporting Vendor
Nice work
LS1FJ40
SILVER Star
How have I not seen this thread?!?!
Pm on its way...
Pm on its way...
Are you printing yourself or is he still mailing them to guys ?
LS1FJ40
SILVER Star
I was hoping he was printing them...
Me too, my 3d printer hasn't happened yet. My floppy vents are super annoying though.
LS1FJ40
SILVER Star
If he isn’t making them I will have the kids at the school I used to teach at make them. I got a 3D printer donated to them a year ago. They’ve made some cool stuff.
BlueCruiser84
SILVER Star
Who is making these? I want a set...
- Thread starter
- #69
I'm making these! Sorry folks, I was away from MUD for about 18 hours. Will try not to let that happen again.
The original ones I made 1 year ago out of PLA are still holding up, but have deformed a little due to the summer heat. I've since switched to ABS which is what the vents themselves are made out of so no worries about heat deformation. I'm going to boot up the printer some time today and get cracking! Once I get some sets in hand I'll PM y'all.
The original ones I made 1 year ago out of PLA are still holding up, but have deformed a little due to the summer heat. I've since switched to ABS which is what the vents themselves are made out of so no worries about heat deformation. I'm going to boot up the printer some time today and get cracking! Once I get some sets in hand I'll PM y'all.
Mdej3
SILVER Star
Pm sent !!!
I have a 3-D printer that I can make them off of
Thanks but I bought new ones.
Amazing. Thank you
Outsane
Supporting Vendor
If you need them printed let me know
