Hey all,
I am working on a 3d model of the drink divider. The Toyota version is fragile and after spending 45$ to get a replacement, only to see it break within 2 months, I decided to make my own.
Below is a photo of the model:
I decided to add some coin slots because that's personally useful to me. But I'm curious about your thoughts and suggestions so I can incorporate them in the model. I've given myself 2 more weeks to improve this version before releasing it for free (this thread and on thingyverse)
Question: the original divider has little arms you can use to stabilize drinks. I'm not sure I can make that but if you think this is critical then I'll give it a shot (more like 25 shots) to see if I can make a version that has it.
All feedback welcome but please note that I'm not a 3d modeling expert so there is a chance this is the best I can do. I'll share a picture of a printed version installed later today or tomorrow. It fits perfectly, tight but still removable.
I am working on a 3d model of the drink divider. The Toyota version is fragile and after spending 45$ to get a replacement, only to see it break within 2 months, I decided to make my own.
Below is a photo of the model:
I decided to add some coin slots because that's personally useful to me. But I'm curious about your thoughts and suggestions so I can incorporate them in the model. I've given myself 2 more weeks to improve this version before releasing it for free (this thread and on thingyverse)
Question: the original divider has little arms you can use to stabilize drinks. I'm not sure I can make that but if you think this is critical then I'll give it a shot (more like 25 shots) to see if I can make a version that has it.
All feedback welcome but please note that I'm not a 3d modeling expert so there is a chance this is the best I can do. I'll share a picture of a printed version installed later today or tomorrow. It fits perfectly, tight but still removable.