- Year
- 2005
- Vehicle Model
- LX470
- Location
- Iowa City, Iowa United States
- Mileage
- 183700
- Color
- White
2005 LX470, White paint, grey interior
VIN JTJHT00W253554285
183,500 miles
$28,750
No rust, very clean (Texas) truck
Fully built but never taken off-road
Fully baselined (over $6000 spent this year in preventive maintenance)
Clean CARFAX available
The built was done by the previous owner 2019-2023, all of these have been added in the last 30k miles:
~155K miles – timing belt and heater Ts
~182K miles:
VIN JTJHT00W253554285
183,500 miles
$28,750
No rust, very clean (Texas) truck
Fully built but never taken off-road
Fully baselined (over $6000 spent this year in preventive maintenance)
Clean CARFAX available
The built was done by the previous owner 2019-2023, all of these have been added in the last 30k miles:
- Dissent high clearance front bumper with Warn VR 10S winch, synthetic rope, Factor 55 fairlead and Prolink
- Dissent rear bumper with tire carrier and aluminum tray swingout
- Slee sliders
- Bumpers, sliders and wheels are custom powder-coated anthracite grey
- Slee diff drop
- 33” KO2s
- Old Man Emu shocks
- Rhino rack
- Dual battery system with Red Arc controller and Solar panel (both batteries are new)
- SPC upper control arms
- Dobinsons dual drawer with fridge slide (3rd row seats are available if you want them)
- 10.2” Android head unit
- Rebuilt dashboard lights with LEDs
- Cobra CB radio and antenna
- Pro Comp front lights
- Cali raised rack-mounted lights
- Under-vehicle lights
- Wolfbox rearview mirror with front and rear camera
~155K miles – timing belt and heater Ts
~182K miles:
- Brake booster (@Toyota dealer, still under warranty)
- Steering rack, fluid and tie rods (@Toyota dealer, still under warranty)
- Radiator and cooling fluid(@Toyota, still under warranty)
- Changed oil (@Toyota dealer)
- Slee steel brake lines (@Toyota dealer, I provided the parts)
- OEM front and rear rotors and pads, pins, rubber boots for sliding pins and new hardware
- Front wheel bearing kit, seals, rings, caps etc (Koyo kit from Cruiserteq)
- Greased needle bearings using the Slee tool
- Font and rear differential fluid
- Transfer case fluid
- PCV valve
- Cleaned throttle body and MAF sensor
- Lubricated the drive shaft and U joints
- Replaced cabin with OEM air filter
- Conditioned seats using Leatherique
Last edited:
