200 series complete headlights with hid bulbs installed
- Thread starter Tin Tin
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
BulletHead
Village Idiot
Dealer.
Check out my projector headlight conversion some posts down. It was a pain in the ass, but a very worthwhile upgrade. Pretty cheap if you compare to what it would cost at the dealer. I was quoted $1700 for the headlight assembly and $700 for the ballast and bulbs on the cheapest online Toyota parts website.
Part number UNIT HEADLAMP:
81145-60f20 Right
81185-60f20 left
Available for picking cars sold in the UAE with electrical equalizer, with the possibility of correction with the standard buttons installed in the cabin. Require minimal rework the wiring in cars 08-11 years of release. If interested, you can set how to display photos.
Last edited:
I would LOVE the rewiring recommendations!!!
Please!!!
Report on installation with pictures can be found http://translate.google.ru/translat...howtopic=13248&view=findpost&p=356399&act=url
Ask any questions I will try to answer.
Installing HID bulbs in a reflector housing is a total no-no. 
Installing or retrofitting projector HIDs with proper cutoffs at the required level or having autoleveling is the way to go. No blinding effect to on coming drivers and 2x increased visibility. I just drove 200miles at night on a s***ty dangerous highway and my eye fatigue was almost nill.
Installing or retrofitting projector HIDs with proper cutoffs at the required level or having autoleveling is the way to go. No blinding effect to on coming drivers and 2x increased visibility. I just drove 200miles at night on a s***ty dangerous highway and my eye fatigue was almost nill.I understand Russian, but I do not know English and have to communicate through the Google translator, which is not always correct brings a sense of what I wanted to write or say. But I think this time will not interfere with communication.
All plugs on the restyled headlights 2012 with those number plates, which are laid out above are suitable for standard wiring cars 2008-11.
Only required to connect:
1. to the wire of the parking light yellow-marker (LEDs) "+" brown "-"
2. Green wire - on the relay lens (beam) it connect "+" on the wires of the lamp beam
3. throw in some places the white and red wires going to the equalizer, pulling the needle out of the slot (if you do not change, the adjustment of the passenger compartment is not working properly)
If the translation turned out not correct, then please ask.
Photos of wires that are connected to the LEDs and controls shutter lenses
AWESOME. Thanks for your time. Your first paragraph was fluent english. Perfect. I need a little help with the numbered instructions.
So. Correct me if Im wrong please.
1. Yellow and Brown wires are + and - and connect the 2012+ LED lights to the 2008-2011 parking lights.
2. The Green wire connects to the high beam + wire on the 2008-2011 models.
3. PLease explain this one better. I have to connect red and wight wires to make the highlight adjuster knob work?
4. What about the pink wire next to the green wire?
So. Correct me if Im wrong please.
1. Yellow and Brown wires are + and - and connect the 2012+ LED lights to the 2008-2011 parking lights.
2. The Green wire connects to the high beam + wire on the 2008-2011 models.
3. PLease explain this one better. I have to connect red and wight wires to make the highlight adjuster knob work?
4. What about the pink wire next to the green wire?
